Applying 2 coats of chalk paint to the pizza pan, allowing plenty of time to dry in between coats.
Apply the welcome sticker to the middle of the pizza pan.
Add a line of hot glue to the inside rim of the now black pizza pan and carefully stick the nautical rope in the glue. Complete this all the way around the inside rim of the pizza pan.
Use heavy duty scissors to trim the rope at the end so that it just fits together with the beginning.
Cut a 4-inch length of the nautical rope and hot glue it to the back side of the pizza pan to form a hanger.
To make the bow, cut the ribbon as follows: one 10-inch piece, two 7-inch pieces, one 6-inch piece, and one 3-inch piece.
Start with the 10-inch and 6-inch pieces of ribbon upside down (lace side down). Fold the ends of both pieces of ribbon towards the back as shown.
Flip the 10-inch and 6-inch pieces over (lace side up) and lay the 6-inch folded piece on top of the 10-inch folded piece.
Use the 3-inch piece to wrap around the middle of the combined bow pieces and add some hot glue to secure it.
Add the two 7-inch pieces to the backside of the top bow section and cut the ends to make them pointed as shown.
Using the wire cutters, trim the lamb’s ear to leave just a few inches of the stem.
Attach the two stems together with a rubber band or twist tie (from a loaf of bread) with one set of leaves up and the other set of leaves down.
Hot glue the lamb's ear to the right side of the pizza pan and hot glue the bow on top to hide the connection.